In het Engels noemen ze het een relay lever:

To remove the relay lever and schaft

1. Working under the verhicle, remove the cover plate hat is neath the pedal cluster
2. Disconnect the tie rods, the steering damper and the drang link from the relay lever.
3. To prefent the spring washer from forcing the lever up and damaging the bolt, clamp the relay lever with a glue clamb (lijmtang). Then remove the nut and clamp bolt from the relay lever
4. Remove the clamb and than the relay lever
5. Using a screwdriver, pry the end cap off the bottom of the relay lever shaft mounting (Alternately, you can drive it with a hammer and cold chisel)
6. Pull the relay lever shaft downward.
7. Inspect the endcap, the upper protection cap, and its gasket. Obtain replacements for any worn or damaged parts.

Installation of the relay lever and shaft is the reverse of removal. Before you install the clamp bolt and nut, compress the spring washer bij installing a clamp (lijnmtang), Torque the nut to 8 - 11 mkg

Install the end caps and grease nipple. Then lubricat the relay lever shaft.

Succes!