still working on it...
i have next week off, hope to get some work done

more stuff bought;

innovate mtx-l wideband lambda controller



mk1 westy grill



16 pieces of 50x20cm damping mats to get the cabin nice and quiet



I wanted a silent exhaust for the RDW check, but stock mk1 caddy exhaust is only available in straw-size. Custom stainless is a bit too expensive at the moment, so i bought an ebay Sharan VR6 anlage i can make fit.
Lots of length, 55mm diameter, nice round mufflers and damn cheap.
Doesn't have to last decades anyways..

ordered on wednesday, got here today already!

Engine bay is pretty solid underneath the dirt and grime;




still gotta weld the corners behind the struts and some small holes, and it's ready for fresh paint

Nice project :thumbup: :thumbup: and nice gti arches. :D :D

International, Rene ;)

Nice work!

mocked up, abf rail is a tight fit

Pictures, or it didn't happen ;)

yeah where did the pic go

:thumbup:

Nice!

oops :)

finally got the MTX-L wideband in and sourced a nice front bumper :)

i just had to try out the wideband :D

Ha ha ... now you know your bike is running ok!

Actually it wasn't. Engine was cold and lots of fresh air because i couldn't hold it in but behind, so the reading was changing all the time. At least i know the controller is fast ;)

Nice project Marc. Now get on with it!:)

bought a new welder and was repairing rusty spots in the enginebay, but slow progress, because i'm busy working on the new website ;)

Can you tell me from what bike this throttle bodies are and what diameter they have?

Mark

if i remember correctly, '01 GSX750R, tapered from 48 to 42mm at the butterfly